Quick Water Heater Maintenance Steps

Posted by on Jan 26, 2016 in Gas Water Heater Repair Gainesville FL, Water Heater Repair Gainesville FL, Water Heater Use and Care

Ready for some water heater maintenance today? It will not likely take long. . .actually we were thinking about 10 minutes. Yep, that could be all it will require to discuss two maintenance chores that any property owner can accomplish. The best part is they should help Gainesville property owners with the following:Gainesville Water Heater Maintenance Steps

Ensuring that ones water heater last for a long time, saving money.
Ensuring ones water heater functions safely and securely.
Making certain it operates as energy efficiently as possible, also conserving money.

So with that in mind, let us educate you on how to invest 10 minutes once or two times a year to help prevent any water heater repairs for your Gainesville water heater.

T&P Valve Testing

The purpose of the temperature and pressure relief valve, also referred to as the T&P Valve, is really essential. It has the important task of ensuring excess pressure will not establish within the storage tank, which in turn makes sure the water heater won’t explode. The infographic below illustrates the next actions in testing it. The lever should be raised a little and then let go of it. It should snap back to its shut location immediately. When it is operating properly, some water may be heard moving into the drain pipe below the lever that was previously lifted and the sound of some pressure released is possibly observed. One will be needing a new valve whenever none of these things occur in the course of the test.

Flushing Some of the Water from the Water Heater

Naturally, rust and sediment will appear inside the water storage tank as a result of the chemical reactions taking place with the parts that are required to heat the water. We will not go directly into the complicated chemical information in this article, but through flushing a little of the water, it can help remove the sediment, and provide an occasion to find out what amount of sediment is in the water heater.

To perform a little flush, put a pail underneath the drain valve, located at the lower part of the tank, and open the drain valve. Simply drain a few gallons of water – a couple buckets full. Enable the water to sit in the last bucket for a handful of minutes. As soon as it settles, assess to see how much stuff has settled to the bottom of the pail. If there is, if the water heater has actually not been drained for a long time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible.

Take note of how clean the water appears. When it doesn’t seem very dirty only executing the mini flush will likely be acceptable. If there is a lot of stuff in the water a complete flush ought to be completed. If you’re sure it has not been flushed for a long time, if ever, it would be recommended to empty all of it.

We will not be going into all the measures in this article to do so, however for educational purposes, initially turn down the temperature. Wait a minimum of one hour to permit the water to cool down prior to draining it. Instead of using the pains, it truly is much easier to connect a hose to the drain valve and drain the water outside the house.

If one starts to listen to strange cracking noises from the water storage tank, it can be a signal that there exists a sizable amount of sediment developing on the inside. This also significantly reduces the energy efficiency of the water heater.

Water heaters will run very well without very much maintenance, and many house owners really do not do any sort of maintenance for them. However, to achieve the 3 benefits mentioned in the beginning of the article, it is vital to at a minimum perform these two responsibilities. If you have any problems or think that you want some help initially, let us know! We are always available to assist and to help prevent an unwanted Gainesville.

Water Heater Repair Gainesville Florida

From Visually.